WaveWare Apollo T-2000 Informações Técnicas descarregar pdf (Página 85)

Certification Manual

- 85 -

Step 3 – Plug the sign into a standard 110v outlet.

Step 4 – Start the software program.

Step 5 – Click the “Link” Button and choose the com port the sign is

attached o on the computer.

Step 6 – Cycle power to the sign as per on screen instructions, the

software will tell you “Success” and it may take a few moments.

If it shows “Failed”, close and reopen the software and cycle

power to the sign again.

Step 7 – After a successful “LINK”, hover/click on the “Pagers” button

and click “READ” to see the information programmed into the

sign.

Step 8 – After a successful “Read”, hover/click on the “File” button

and click “Save As” to save this information as a “Default”

file, in case it is ever needed for resetting the defaults.

Step 9 – Enter the desired Capcodes, Baud Rate, and Frequency.

Step 10 – Hover/Click on the “Pagers” button in the menu and then

click “Write” to program the values you have entered.

Step 11 – Hover/Click on the “File” button and click “Save As” to save

your programmed data.

Step 12 – You Must cycle power to the sign before it will receive and

display any messages after programming.

Step 13 – Other programming is done “Over the Air”: See the “AS

Series LED Sign Configuration” Table for standard

programming commands.

Programming “Over The Air”

Once the Capcodes, Baud Rate and Frequency have been

programmed, the Wall Pager settings can be changed by manually sending

programming commands via a standard Paging Encoder that is set to

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 113 114

Sem comentários

WaveWare Apollo T-2000 Informações Técnicas Página 85