WaveWare Apollo T-2000 Informações Técnicas descarregar pdf (Página 32)

Certification Manual

- 32 -

Wire Management

We have previously mentioned some wire management issues such

as protecting wires in the Mud Ring Boxes from sheetrock compound,

keeping all wires out of high traffic areas such as catwalks, etc. When

crossing a catwalk run below it or use some sort of hangers to get the wire

high enough so that it is not a choke hazard. When using junction boxes,

make sure that all cables are labeled and that the wire nuts are on tight and

secured with electrical tape, and that the box lid is labeled as well. In the

enclosures, use nylon “wire ties” or “zip ties, and their “anchors” (see figure

14) to keep wires together in a neat arrangement. Again each wire should

be labeled for future identification should future service work be needed.

When bundling wires together with “zip ties”, slide the tie through the

anchor’s slots, loop the tie through its own slot and pull until the wires come

together until the cable bundle makes up about 50% of the circumference.

Make sure that you clip off the excess tie part in a straight cut so that the

end is not a sharp point. Also, when clipping this excess off, you obviously

want to ensure that no wires will be damaged.

Figure 12

: Wire tie and anchor

Nylon Wire Tie

Self Adhesive Wire Tie Anchor

Wires

Snug up but leave a

little space ~ 50%

Wire Ties

slide

through

these

Peel paper off

of back side

adhesive

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 113 114

Sem comentários

WaveWare Apollo T-2000 Informações Técnicas Página 32