Waveware comPPage DVIF-10 Manual do Utilizador

DVIF10

Alarm Interface Utility Software V3.1.3 Jumper Setting DVIF10 (Single or w/Slave) Scope Transmitters On Slave 2 & 3 Cable

Alarm Interface Utility Software V3.1.3 Specifications Input Voltage 12 Volts DC Current 750 mA maximum, Normal – 425mA Input Contacts 10 per

Alarm Interface Utility Software V3.1.3 Diagram #1 Serial Cable to Paging Transmitter 12

Alarm Interface Utility Software V3.1.3 Diagram #2 13

Alarm Interface Utility Software V3.1.3 14

Alarm Interface Utility Software V3.1.3 2 Information in this document is subject to change without notice. Companies, names, and da

Alarm Interface Utility Software V3.1.3 DRY VOLTAGE INTERFACE 10 DVIF10 The Dry Voltage Interface 10 (DVIF10) is an alarm contact input device w

Alarm Interface Utility Software V3.1.3 INSTALLATION 1. Insert CD into the CD-R or CD-RW drive, the CD will auto start. 2. If auto start does not

Alarm Interface Utility Software V3.1.3 COMP2 Protocol 1. Select Slave Amount, 0=None, 1,2,3 2. Select Comp2 paging protocol and serial por

Alarm Interface Utility Software V3.1.3 Writing Data to Unit NOTE: WHEN WRITING or READING FROM THE DVIF10 ALWAYS USE A NULL MODEM CABLE 1. A

Alarm Interface Utility Software V3.1.3 7 Single Unit Installation 1. Mount DVIF10 in selected location with supplied hardware. 2. Connect Alarm

Alarm Interface Utility Software V3.1.3 8 Master and Slave Procedure Each unit must be programmed separately. The master will have contact

Alarm Interface Utility Software V3.1.3 9 Installing Master and Slave Units for PagingNote: Ensure jumper settings are correct for the paging trans